Remember the Status Bar and Think Edges

Two little practical tips or reminders for Friday morning.

Tip One - Revit doesn't see things until you place your cursor near the edge of an element. There are some exceptions but for most elements you've got to move the cursor near an edge. Not sure if Revit sees it? Is it highlighted? No, then Revit doesn't see it. No point clicking to select something if Revit doesn't acknowledge it. The highlighting is visual confirmation that Revit thinks "this" is what you want to select.

If it isn't the correct one, remember the TAB key cycles through alternate elements that Revit could see in the same spot. I imagine sonar radiating from the tip of the cursor. If an element is close enough to bounce a signal back to the cursor you can "sink the battleship". No "Disco Tabbing", that happens when you hold the tab key down instead of just pressing once or twice as needed. I say disco because elements flash at you when you hold the button down. Thanks to Cyril Verley for that, I heard it from him first.

Okay that was three tips already; Edges, Highlighting and the TAB key.

Tip Two - When you are busy remembering edges don't forget to remember the Status Bar. It tells you what Revit sees or wants from you. When you place your cursor near an element you get the highlighting, you should see a tool tip AND the Status Bar offers you some info too. It's like a read-only command line, sssh.

Dept. of Echo - Tab Key

Echoing my own posts this time. Just a little reminiscing, but first a question...

Tab is?
A) A delightful diet soda
B) Your bar bill
C) Part of the delightful ribbon interface
D) Texas Association of Broadcasters
E) A key on the keyboard and tool in Revit
F) All of the above

The answer is "F", all of the above. The question now is, "Which one is more relevant to this post?" Well... "E" naturally.

I posted this as a reminder on July 10, 2008. Beware the "Disco Tabbing"!
I posted this and a video on October 22, 2009. I've embedded the video again here for some instant gratification.

Dept. of Subtle - TAB Key - Entire and Partial Chain of Lines or Walls

This is subtle feature of using the TAB key that many users are not aware of. First of all, it is easier to see than to describe so you might as well watch the VIDEO.

Two items:

• Select Entire Chain of Walls or Lines
  
• Select Partial Chain of Walls or Lines

First item - Hover cursor over a wall or line > Press TAB key once (Walls or lines highlight) > Left Click to select.

Second item - Select a wall or line > Hover cursor over a different wall or line somewhere along the path > Press TAB once (Walls or lines highlight) > Left Click to select. The subtle difference is that which direction the selected chain travels depends on which end of the element you hover your cursor over. Watch and then try it!

NO DISCO tabbing, as my friend Cyril says. Just press the TAB key once. You get the disco tabbing when you press and hold the TAB key down. We call it Disco because the highlighted lines will flash at you.

Last comment, make sure you hover and then hold your mouse steady. If you move the mouse away after highlighting the chain the TAB feature fails. You have to make sure everything is highlighted still before using the Left mouse button to select them. It is a process unlike any other software you are familiar with most likely. Practice a couple times if you aren't already very comfortable with it.