tag:blogger.com,1999:blog-9240097.post6676393777255100324..comments2024-03-26T21:47:32.774-07:00Comments on Revit OpEd: Dimension between Concentric ArcsStevehttp://www.blogger.com/profile/14230364057800484763noreply@blogger.comBlogger3125tag:blogger.com,1999:blog-9240097.post-90350280841203108942015-08-24T16:21:26.490-07:002015-08-24T16:21:26.490-07:00Cool...assuming I've got something that is alr...Cool...assuming I've got something that is already perpendicular to them.Stevehttps://www.blogger.com/profile/14230364057800484763noreply@blogger.comtag:blogger.com,1999:blog-9240097.post-6121368862600898692015-08-24T16:04:24.829-07:002015-08-24T16:04:24.829-07:00The reference line is required to tell Revit how y...The reference line is required to tell Revit how you want the dimension oriented. Try drawing a line or reference plane perpendicular to where you want the dimension string, start a dimnesion on that line, then reference the curves (you can dimension both 'sides' of the circle), then 'place' the string. you can now delete the object, or edit the witness lines of the string to remove the unwanted reference.Tim Westhttps://www.blogger.com/profile/12776013697406718974noreply@blogger.comtag:blogger.com,1999:blog-9240097.post-56837897430977385772015-08-24T02:34:52.635-07:002015-08-24T02:34:52.635-07:00you can also place a detail line from one arc to t...you can also place a detail line from one arc to the perpendicular of the next. break the line so it is only a segment between the 2 arcs. dimension this line then using the witness line tool pick the 2 curves. once this is done delete your detail line.Anonymousnoreply@blogger.com