tag:blogger.com,1999:blog-9240097.post9149812939774696923..comments2024-03-26T21:47:32.774-07:00Comments on Revit OpEd: Reveal Elements - Hidden ViewportStevehttp://www.blogger.com/profile/14230364057800484763noreply@blogger.comBlogger2125tag:blogger.com,1999:blog-9240097.post-55267267723000357842018-11-13T05:53:25.061-08:002018-11-13T05:53:25.061-08:00I have been using this "feature" this we...I have been using this "feature" this week. =D<br />I have an RCP plan, and an MEP firm that did a bad job at revit. <br /><br />There stuff was only drawn at one typical floor, in a floor plan view. Since it was a floor plan view - I was unable to link the view in my RCP.<br /><br />Since we only wanted to see the ductwork in the RCP temporarily. I created my RCP and put it on a the sheet, then I created a wireframe <b>plan</b> view that linked directly to their typical mechanical plan view. Then aligned them on the sheet. Once we no longer wanted to print with the ductwork overlay, I slide the view down and hide it. It does not effect the plot setup.<br /><br />Blue442https://www.blogger.com/profile/04092465131948584425noreply@blogger.comtag:blogger.com,1999:blog-9240097.post-3881704222291532432018-10-18T06:57:58.459-07:002018-10-18T06:57:58.459-07:00We have people who do this in order to "Hide&...We have people who do this in order to "Hide" the View Title. We have a Viewport Type named "No Title" - so it's not necessary for them to use the "Hide in View" technique. In general, we discourage people from using "Hide in View" at all - especially when there are other/better alternatives. It should be a last resort. So, I say it's BAD!IntegratedPractitionerhttps://www.blogger.com/profile/04858663543245478296noreply@blogger.com