tag:blogger.com,1999:blog-9240097.post7029933728241177557..comments2024-03-28T14:45:49.929-07:00Comments on Revit OpEd: STC - Spot Dimension > Spot Elevation Won't WorkStevehttp://www.blogger.com/profile/14230364057800484763noreply@blogger.comBlogger4125tag:blogger.com,1999:blog-9240097.post-90851653675146265902009-11-27T08:54:02.139-08:002009-11-27T08:54:02.139-08:00Thank you to brilliant afaq!Thank you to brilliant afaq!Anonymousnoreply@blogger.comtag:blogger.com,1999:blog-9240097.post-11067700277167982662009-06-02T12:55:25.722-07:002009-06-02T12:55:25.722-07:00Don't believe so, there is nothing in the "center"...Don't believe so, there is nothing in the "center" of the pipe. The symbolic line is just that...symbolic so even using wireframe I don't think that the spot dimension tool will "see" the center.Stevehttps://www.blogger.com/profile/14230364057800484763noreply@blogger.comtag:blogger.com,1999:blog-9240097.post-82617073284597489262009-06-02T08:56:54.808-07:002009-06-02T08:56:54.808-07:00Is there any way that the spot elevation can be ap...Is there any way that the spot elevation can be applied to the center of a pipe in plan view in Revit MEP 2010? It will go to the top and bottom but not the center? ThanksJon Weinholdhttps://www.blogger.com/profile/06388688321025096156noreply@blogger.comtag:blogger.com,1999:blog-9240097.post-42025371412822386272008-10-10T21:12:00.000-07:002008-10-10T21:12:00.000-07:00Remove the room color fill applied to the view and...Remove the room color fill applied to the view and then place the spot elevation, it will work.<BR/><BR/>AfaqAnonymousnoreply@blogger.com